Smart Electronic Fingerprint Lock Smart Home Electronics Door Lock Large Indoor Remote Control By key/card/Password/Mobile App/bluetooth unlock

Smart Home Electronics Door Lock Large Indoor Remote Control By key/card/Password/Mobile App/bluetooth unlock

Specifications:

Item type: Smart door lock

Color: Silver/Black/Red bronze

: Mechanical key/card/Password/Mobile App/bluetooth unlock

Chip grade: Class B blade lock

Applicable door thickness: 35-70mm/1.37x2.73inch

Panel size: 306x75x12mm/11.94x2.93x0.47inch

: 800mah Lithium Battery

: Micro USB

: 500ms

:  : 20 includes 2 for admin.

: 508dpi

: 0.25s

:  :  :  :  : ~+55℃

: ~85%(No condensation)

Warning: DO NOT charge with rapid-charging cable

(1cm=10mm=0.39inch)

Measurement Details in the attached picture.

Package include:

1x Smart Electronic Fingerprint Lock

1x English manual

Feature:

-100% brand new and high quality.

-Five unlocking methods:Mechanical key, card, password, Mobile App, bluetooth unlock to meet your various requirements.

-304 stainless steel material, anti-corrosion.

-.

-.

-Easily unlock with just one touch: The design is simple and generous. Feel the infinite charm of technology through one touch.

-Applicable places: residential areas, star hotels, commercial office buildings, villas, etc.

-Applicable doors: wooden doors, steel doors and various composite security doors with a thickness of 35-70mm.

Installation instructions

① Choose the suitable length of the adjustable bolt (60mm or 70mm), and install the lock as shown below(Pay attention to the direction of the bolt while installing.)

② Confirm the open direction of the door(Note: the default direction is set for right-handed doors, hallway-mode and the deadbolt tailpiece is fixed.)

Choose the door opening direction by rotating the deadbolt tailpiece. Rotate counter-clockwise till locked for right-handed door, rotate clockwise till locked for left-handed door.

When to install on left-handed door, please remove the setting cap and connect the lock to the power supply and click the mode switching button. Then disconnect the power, rotate the tailpiece clockwise till locked, and switch the anti-lifting screw to the opposite direction before installation.

③ Install the outer handle(with the fingerprint recognizer), stick the tailpiece of the outer handle and the data interface into the square hole of the lock.(If installed for left-handed door, please make sure that the tailpiece is rotated clockwise and is locked before sticking in.)

④ Use a pin or needle to press the square hole, then take out the setting cap(the inner handle without fingerprint recognizer)

⑥ Screw the two long screws into the swivel nuts(please note that at this time, the handle should be placed horizontally or slightly upswept. Screw the screws tightly and press down or lift up the handle a little to test the smoothness.), complete.

Notice

-Please allow slight deviation of measurement due to manual measurement.

-Due to different monitors and different light, the picture may not reflect the actual color of the item.

-Please consider the actual sizes shown in the listing as the pictures are generally enlarged to show detail.