SI24R1 NF-01-S 2.4G Wireless Serial Module Transparent Transmission
- Stock: In Stock
- Model: EB0042426
- SKU: EB0042426
NF-01-S is a 100mW power 2.4G wireless module, high-altitude rate (up to 2Mbps), using SPI interface, send and receive in one pure hardware module; high stability, cost performance, Volume, use of all-industry components.
Has been mass production and reached millions of shipments, and applies to a variety of application scenarios.
NF-01-S can be widely used in a variety of networking occasions, suitable for wireless mouse and keyboard, wireless remote control, somatosensory equipment, active RFID, NFC, low power consumption network of wireless sensor networks, is the ideal solution of Internet of Things application.
NF-01-S adopt DIP-8 package, whether learning or mass production, can quickly docked to existing products, no need soldering, direct plug, easy to use.
Information link:
Features:
• DIP-8 ultra-small package, built-in 2.4G antenna, small size, easy to use
• Supports data reception for six channels
• Supports common modulation such as GFSK / FSK
• Supports 2Mbps / 1Mbps / 250Kbps data rate
•Multi-frequency: 126 frequency, to meet the needs of multi-point communication and frequency hopping communication
• Internal integration of high PSRR LDOs
• Wide supply voltage range: 1.9 ~ 3.6V
• Average emission current as low as 110mA
• Receiver sensitivity: -96dBm @ 250kbps
• Maximum transmit power: + 7dBm
• Four-wire SPI interface for up to 10MHz
• Internal Integrated Smart ARQ Baseband Protocol Engine
• Transmit data hardware interrupt output
• Supports 1bit RSSI output
• Low application cost: The SI24R1 integrates all the high-speed signal processing parts associated with the RF protocol, such as automatic retransmission of lost packets and automatic generation of response signals. The SPI interface of the SI24R1 can be connected using the microcontroller's SPI port or using the microcontroller I / O port to simulate, the internal FIFO can be with a variety of high and low speed microprocessor interface, easy to use low-cost single-chip.
• Easy to develop: Since the link layer is fully integrated on the module, it is very easy to develop. Automatic retransmission function, automatic detection and retransmission of lost packets, retransmission time and the number of retransmission software can automatically control the automatic response is not received a reply signal packet automatic response function, after receiving the valid data, the module automatically sends a response Signal, no additional programming Carrier detection - Fixed frequency detection Built-in hardware CRC error detection and point-to-multipoint communication Address control Packet transmission error Counter and carrier detection function can be used for frequency hopping settings can be set at six simultaneous receive channel address, can be selective Of the open receiving channel standard pin DIP 2.54mm pitch interface for easy embedded applications.
Parameter:
| Model | NF-01-S |
| Package | DIP-8 |
| Size | 28.6*15.3*3.2 mm |
| Communication Interface | SPI (The maximum rate of up to 10Mbps) |
| Air rate | 250k~2Mbps, 3 Level adjustable(250kbps,1Mbps,2Mbps) |
| Spectral range | 2400MHz~2525MHz adjustable, 1MHz Step forward |
| Antenna form | Onboard PCB antenna, gain 2dBi |
| Maximum transmit power | 7dBm |
| Receiving sensitivity | -96dBm@250kbps |
| Average current | Emission current: 25mA(7dBm) Receive current: 15mA (2Mbps) Shutdown: current 1.0uA(Shutdown Mode) |
| Power supply range | 1.9~3.6V, Typical value 3.3V |
| Operating temperature | -20 ℃ ~ 85 ℃ |
| Storage environment | -20 ℃ ~ 90 ℃ , < 90%RH |
Pin Explanation:
| NO. | Name | Direction | Use |
| 1 | VCC | - | Power supply, must be between 2.0 ~ 3.6V |
| 2 | GND | - | Ground, connected to the power supply reference ground |
| 3 | CSN | Input | The module chip select pin, is used to start an SPI communication |
| 4 | CE | Input | Module control pin |
| 5 | MOSI | Input | Module SPI data input pin |
| 6 | SCK | Input | Module SPI bus clock |
| 7 | IRQ | Output | Module interrupt signal output, low level active |
| 8 | MISO | Output | Module SPI data output pin |
Package included:
1 x SI24R1 NF-01-S 2.4G Wireless Serial Module
Shipping Time
After you successfully placed an order at RenhotecIC.com, you will receive a confirmation email with your invoice. Once your order is shipped, you will be emailed with the tracking information of your package. Also, you can choose your preferred shipping method during the checkout process. Kindly advise: please select DHL/FedEx if you need our product urgently.
The timeline of the whole shipping process is shown below:
The total delivery time is calculated from the time your order is successfully placed to the time received. Total delivery time is broken down into processing time and shipping time.
Processing time: The time it takes to prepare your item(s), includes preparing your items, performing quality inspections, and packaging for shipment. Normally, the processing time is 1-3 days (Only include Monday to Saturday ) after getting your order.
Shipping time: The time for your item(s) to travel from our warehouse to your destination. The shipping time depends on the shipping method you chose. Please refer to the shipping rate section for details.
Shipping Rates
You could choose the shipping method based on your preference during checkout, different shipping methods will apply different rates and shipping times. Please check the following chart for detail:
You could choose the shipping method based on your preference during checkout, different shipping methods will apply different rates and shipping times. Please check the following chart for detail:
| Shipping Method | Shipping Rates | Shipping Times |
| Flat Shipping (Promotion) | $10 | About 5-30 Working Days to Worldwide (Only include Monday to Saturday ) |
Standard Express（0.5KG starting price listed） | Based On Weights | About 5-15 Working Days to Worldwide (Only include Monday to Saturday ) |
Priority Express （0.5KG starting price listed） | Based On Weights | About 3-7 Working Days to Worldwide (Only include Monday to Saturday ) |
In addition, the transit time depends on where you're located, the shipping method you choose, and where your package comes from. We will keep you informed of any problems here to help you get your order as soon as possible.
If you want to know more information, please contact the customer service by contact form or sales@renhotecic.com. We will settle your problem as soon as possible. Enjoy shopping!
